Delta 1010LT with outboard gear

[premiumdan]

Hello.

Sonic Foundry (Sony) Acid Pro 4.0
Sonic Foundry (Sony) Sound Forge 9.0

Is this possible to do this WITHOUT getting feedback?

Set Acid to play on OUT-3/4, run the signal through my rack compressor & EQ, set Sound Forge to record on IN-5/6, and use the 1010LT monitor-mixer on OUT-1/2

Assuming that I have my physical IN/OUT routing correct, of course...

Thanks for your time.

-Dan

[JA]

Yes, you would only get feedback if you fed a device's output back into its input. You'll want to turn down the Wave out 3/4 (software output 3/4) in the monitor mixer and turn up inputs 5/6 so you are monitoring the compressed/EQ'd signal.