Connect Technics 1210 turntable to Omni IO box?

[daver]

can it be done, checking info on various sites would suggest its possible to route a turntable (RCA) into the Omni IO box and then on into the Delta 66, cant quite see the connection on the Omni IO where youd run it into though?

Anyone help? Thanks :)

[DonnieC]

You have to use an adapter if it doesn't have 1/4" plugs - I run a reel to reel tape deck into mine that way, it has RCA/phono outputs. I'm using an RCA to 1/4" cable I picked up at Radio Shack. I plug it into inserts 3 & 4 on the back of the unit and then just have a profile I load for that config.

[DonnieC]

Almost forgot - make sure to check the switch on the back that's right above those inserts, I don't remember if it's pressed in or out that specifies using those inserts.

[JA]

You really need a phono preamp for your turntable. Even if you used adapter cables to connect the turntable, there is nowhere to ground it.

[daver]

the turntable goes through an integrated pioneer amp where it is grounded, i thought running on into the IO Box from the amp may allow me to change the record input level where ness? Is that possible?

[JA]

There is no level control over the line inputs, however, you could try running into the 1/4" instrument inputs on the front and adjusting the gain there.