Mic input issues - one side only

[carlyle]

1010LT issue. For some reason my mic input is only audible on one channel while monitoring. How can I make sure it's audible on both through the headphones? Also, how can I add reverb to the monitored channel for vocals? Thanks.

[JA]

<moved to Delta Series section>

If you are directly monitoring via the Delta Control panel, you need to center the pan for the input channels. If you are monitoring via your recording software, you need to be recording to a mono track, not a stereo track.

Unless you have an outboard effects processor to add reverb with, you should be able to set this up in your recording software. You'll need to enable software monitoring and disable direct monitoring (make sure outputs 1/2 are assigned to the sw rtn and not the monitor mixer).